Peaceful Christmas
· STAMPS – Peaceful Cabin (156395), Sparkle of the Season (156518)
· PAPER – Basic Gray (121044), Basic White (159276), Smoky Slate (131202), Peaceful Place 12” x 12” Specialty Designer Series Paper DSP (156394), Silver Foil 12” x 12” Specialty Paper (156457)
· INK – Smoky Slate (147113), VersaMark Pad (102283)
· OTHER – Layering Circles Dies (151770), Heat Tool (129053), Clear Block A (118487), Clear Block D (118485), Tear & Tape Adhesive (154031), Multipurpose Liquid Glue (110755), Mini Glue Dots (103683), Glittered Organdy Ribbon (156408), Simply Shammy (147042), Paper Snips Scissors (103579), Bone Folder (102300), Silver - Metallics Stampin’ Embossing Powders (155555),
Cutting & Scoring:
Basic Gray – 5-½” x 8-½”, score at 4-¼”
Silver Foil Specialty Paper – 5-3/8” x 4-1/8”, scrap (behind sentiment)
DSP – 4” x 5-¼” (snowflakes), 3” x 3” (cabin)
Basic White – scrap
Smoky Slate - 4” x 5-¼”
Glittered Organdy Ribbon – 6”
Instructions:
Die cut the DSP with the cabins using the 2-15/16” circle die.
Die cut, using the 2-15/16” circle die, from the center of the silver foil paper then use the next smaller circle die to cut a circle out of the center of the first die cut circle.
Adhere the silver foil circle ring using liquid glue on top of the DSP circle.
Using the VersaMark pad stamp the sentiment on the scrap piece of Basic White card stock, sprinkle with silver embossing powder and set with heat tool. Cut each end at an angle.
Cut the scrap piece of silver foil paper 1/8” smaller in width than the Basic White scrap adhere behind the sentiment and cut each end at the same angle as the Basic White.
Stamp sentiment of your choice from either stamp set on the Smoky Slate card stock using the Smoky Slate ink then stamp the small snowflakes from the Peaceful Cabin across the bottom.
Fold and burnish the basic gray card stock using your bone folder.
Adhere the large piece of silver foil paper with the circle cut out of the center to the front of the card base using liquid glue.
Adhere the snowflake DSP to the front of the silver foil paper using tear & tape.
Adhere the DSP circle with the cabins and the silver foil paper to the upper front of the card using liquid glue.
Adhere the sentiment to the lower front of the card using liquid glue.
Tie a knot in the ribbon and adhere to the bottom of the silver foil circle just above the sentiment using a mini glue dot, cut as desired.
Adhere the Smoky Slate card stock to the inside of the card base.
